Page 1 of 1
Sheetmetal on 4 speed bench car
Posted: Mon Nov 12, 2007 9:11 am
by general
Does anyone have pictures of what the hump area of a 4 speed/bench car should look like underneath. I posted what I have to deal with but I would like pictures of what it should look like. The prior owner changed the floor pan under the drivers feet and also cut up into the 4 speed hump. Any information would be appreciated.
Thanks Norm
Ick
Posted: Tue Nov 13, 2007 8:43 am
by moparmodeler
I wish I could help. If the floor pan was copped up bad enough you may hve to replce a part of it befor you can add the hump. Scan the Mopar Muscle web sight I think the did an artical on a 71, 71 B-body four speed convesion.
Posted: Sun Nov 18, 2007 9:21 pm
by general
Well I guess no one has a car under construction that could take a picture. Any ideas where I can go and find this information out.
Posted: Mon Nov 19, 2007 5:15 pm
by ajcpaperboy
This is of my 3 speed bench 71 road runner I hope it might help
Posted: Mon Nov 19, 2007 5:18 pm
by ajcpaperboy
These were my only 2 shots