Page 1 of 1
Florr re-enforcements for buckets seats
Posted: Wed May 31, 2006 6:50 pm
by road chicken
I changed my chicken over to buckets from the stock bench- I know there is supposed to be a plate for the inside( next to the drive shaft hump) mounting studs- on the interior side.
Question- is there supposed to be one under the floor also. If so- does it look like the one in the interior. IE just a HD plate?
Thanks, RC
Posted: Wed May 31, 2006 9:19 pm
by bruce
Okay, I KNOW this is an e-body, but it's a great shot that shows the reinforcements you're talking about. They're very similar if not the SAME on our b-bodys.
Posted: Wed May 31, 2006 11:04 pm
by road chicken
Perfect!!! Thats what I needed to see. Thanks Bruce!!
Posted: Thu Jun 01, 2006 12:24 am
by Eric
Interior braces just in case you need to see them...
Posted: Mon Jun 05, 2006 12:29 am
by 1bluegtx
You guys sure b-bodies came with these plates on the outside of the floorpan?Mine has none,it has the interior plates but just a nut and washer on the exterior?
BRIAN
Posted: Mon Jun 05, 2006 9:46 am
by road chicken
I'm not sure if they came with it, but I'll add them- just cause I need all the extra beef to handle my fat a$$.
